The factory 19-inch wheels on my Model YL came with wheel covers. These days, though, I drive with the covers off, and with them gone, the lug nuts are on show. So I bought a set of Model YL nut caps on AliExpress to tidy them up.
At first I thought about switching to closed-end lug nuts, but in the end I went with caps that simply push on over the nuts. Here’s how it went.
Take the covers off and the lug nuts are on show
This is the factory 19-inch wheel with the cover removed.

You can see all five nuts and the hub in the middle. Before, with the cover on, all of that was hidden.
I explained how I take the covers off in this post.
Why I chose nut caps over closed-end lug nuts
Of course, if you want to hide the nuts, you could swap them for closed-end lug nuts. But I felt caps that just slip over the nuts would be enough.
Being able to pick a colour was a plus too. They came in silver and black, so I bought both.
21 mm nut caps from AliExpress, 20 each in black and silver
What I bought were 21 mm nut caps. Sizes on offer: 17 mm, 19 mm, 21 mm. Each bag has 20 caps.
The Model YL has five nuts on each of its four wheels, 20 in total, so one bag covers the whole car.
The listed prices were 300 yen (about $2) for silver, 250 yen (about $1.60) for black. After coupons, I actually paid 212 yen for the silver set. Meanwhile, the black set came to 177 yen.
I ordered on 1 November. They arrived on the 6th.

Here’s what was inside: 20 silver caps plus 20 black ones.

These are the ones I bought. Silver and black are both on the same product page.
The black ones are for the black wheels I’m getting ready for winter. I looked into fitting 18-inch wheels on the Model YL here.
Silver Model YL nut caps on the factory 19-inch wheels
To begin with, I fitted the silver caps on the factory wheels.
This is the front wheel before.

To fit them, you just push each cap on over the nut. I didn’t use any tools.
Here’s the front wheel afterwards.

Side by side, it looks like this. Before is on the left, after is on the right.

Then I did the rear wheels the same way. Here they are before and after.


Next, I’d like a centre cap
Once the nuts were covered, the hub in the middle started to bother me. Since the wheel cover is off, I’d like a centre cap as well.
I measured the centre hole of the wheel with calipers. It came to 64.0 mm.

The calipers I used cost 211 yen (about $1.30) on AliExpress.
Also, it doesn’t have to be a genuine Tesla part. A generic one is fine for now, so I’m going to start looking.
Model YL nut caps just push on and change the look
In short, I fitted 21 mm nut caps to the exposed lug nuts on my Model YL with the wheel covers off. Without changing to closed-end nuts, the bare-nut look was gone as soon as the caps went on.
A bag of 20 costs around 300 yen, and fitting them is just a matter of pushing them on. If you buy a second colour, you can match your winter wheels too.
As for a centre cap, I’ll try one once I find a good one.
For the car itself, Tesla’s Model Y page is the official reference.
This article is also available in Japanese.









